Uncover the battery-release latch and press down on with one hand, and then pull the battery straight from the case, setting the pc battery aside.
The convenience offered by the portability of a computer can
become a hindrance a result of screen malfunctions? it will not be easy to
connect a new monitor too with a desktop structure. If the backlight
of this LCD screen has was unable, you can see almost any image. To fix this
problem, the entire inverter board and also its particular connected LCD cable needs
to be manually swapped out. Here below are the instruction for your personal
reference.
1. Check while in the manual of your laptop or search the infomation from
the Internet to support the component of the manufacturer抯 websites. Solely
get that what type fo inverter board you absolutely need for your computer, take on
my Pavilion DV2000 Computer screen as instance, I invest in a right one from an experienced site, HooToo. com, and next i fix it on my own.
2. Turn off the particular laptop抯 operation system. Close the LCD screen
motorcycle. CTurn the whole laptop over therefore, the bottom end of the way it is is facing
up for you. Locate the battery-release latch and press down on
with one hand, and then pull the battery straight from the case, setting the pc battery aside.
3. Locate the rubber pieces to the edges and the top LCD. Pop the
stopper pieces away from the case by inserting an appartment object underneath
them and next pulling out toward people. Use a screwdriver to retrieve the
screws hidden under the stoppers.
4. Put the norebook back over and open the LCD screen save.
Slide a flat and also thin object, such for a screwdriver, directly
underneath the seam of your plastic bezel underneath the LCD screen.
Wiggle the screwdriver top to bottom gently until the bezel pops heli-copter flight
case. Lift the bezel up and make sure if there is your cable running to
typically the motherboard. Disconnect the cable whenever a one.
5. Pull the outcome on the screen in your direction, and then remove the item from
the laptop. Locate the inverter board end of it of the screen and additionally
find the cable running with the inverter board to your motherboard. Pull
off the strip of tape to the board and remove the screws holding it with
place if there are any against your particular model of laptop. Disconnect
the cable out of your motherboard.
6. Connect a motherboard cable for plastic-type bezel and place the bezel
back onto a laptop case. Finally, just put the battery towards the laptop
and power them on, and then should the manufacturer抯 logo appear to the
screen, it mean that you are currently successfull to install the fresh inverter
board and cord rightly.
Article Tags:
Inverter Block